User`s guide

Page | 8
Step 10 - Apply Wi-Fi Network Security Settings
By default, the ZuniDigital ZGR304 broadcasts as an OPEN network with no data encryption. If you wish to enable
network encryption to help secure your network, please select the encryption type you want to use, establish a password
that you can remember, and then click the “Finished” button. This will finalize the settings for your ZGR304 and you
may begin using it as a wireless router.
Step 11 - Using the ZGR304 Router
Attach the Ethernet cable that provides your Internet connection into the WAN (Internet) port, (this is typically from a
cable or dsl modem) then power the ZGR304 router ON and wait for it to fully boot. The router will broadcast the SSID
setup in step 9 and now you can connect wireless devices to the ZGR304.
RESTORE FACTORY DEFAULT SETTINGS
Should you at any time wish to restore the factory default settings press and hold the “Reset” button on the
bottom of the ZGR304 Router for 10 seconds, then release. The router will re-boot and all of the original
factory settings will be restored. You can then change the settings as you see fit. Also, you can use the
reboot process if you forget your password and wish to set up a new one. Remember when you reboot the
router will operate as an open mode, and you will need to reenter a password to protect you network.