Instructions / Assembly

Net Sleeve

Spring Lock Spring Lock

Spring Lock

Thickest

Thinnest

Detail A

1. Take out the telescoping poles out of the case.

Insert the thickest part of the telescoping pole (#1)

into the holes on the ends of the case (#7) until

you hear the spring pin lock in place. See Figure

2 and Detail A.

2. Once the telescoping poles are secured in the

case, carefully pull from the top pole (#4) until all

the poles are extended and the spring pins

automatically lock in place. See Figure 1.

Figure 1

Figure 2

SET-UP:

1. Take-Down is reverse of Set-up, make sure you

store all parts back in the Storage Case.

TAKE-DOWN:

- 2 -

NOTE:

To prevent the game from

tipping over in windy conditions

or when playing on uneven

ground place a weighted object

inside the Storage Tray (#8).

NOTE: If rubber caps (#11) are not already pre-

installed to poles (#4) slide them on the end of the

tube as shown in Figure 1.

3. Insert the thinnest part of the telescoping pole (#4)

into the sleeve on one end of the net (#5) and then

carefully insert it on the other end. See Figure 1.