User Manual

5 6
7
v _2G35 20719
Reset voltage
values stored
in memory
1 time
2 times
To reset, press the max or min button.« » « »
Correction of voltage
(factory setting 0 ,
±20 )
V
range V
To switch between the corrections of each phase, press
the middle button, the fourth press returns to the
functional menu.
You can use correction if voltage indications on the
screen of the device and your reference device differ.
The manufacturer reserves the right to modify the
firmware to enhance the device technical characteristics.
3 times
hold
12 sec
Phase sequence control
( on )
factory setting
« »
Viewing
of firmware version
In case of violation of phase order, the current
phase order and the voltage on them will
alternate on the screen. The order
of the phases is always determined relative
to phase L1.
current phase number
correction value in volts
It is necessary to: Ensure supply voltage presence.
Possible cause: There is no power supply voltage.
At turning on neither indicator nor screen do not shine
Hold the three buttons at the same time for more than
4 sec. The indicator will display After release,
reset to factory settings and reboot will take place.
L1 . « » « » dEF
Reset to factory settings
View of calculated line voltages
Hold the middle button for 3 seconds. The respective
screens will display the phase numbers between which the
line voltages are calculated. When released, the screens
will display the calculated line voltages with an accuracy of
2-3 V for 30 seconds or until the middle button is pressed.
Readings can be displayed if Phase sequence control
function is enabled (see Table 1).
« »
Press
« »≡
NotesTable 1.
FUNCTION MENU
Screen
Low Voltage Directive 2014/35/E U
1 30 UEMC Directive 20 4/ /E
Manufacturer and vendor: DS ELECTRONICS, LTD
04136,
[phone] , : [phone]
[e-mail] www.ds-electronics.com.ua/en/
Ukraine, Kyiv region, Kyiv, 1–3 Pivnichno-Syretska str.
48 1 48 1Service Center
SAFETY INSTRUCTIONS
Carefully read and become aware of yourself these
instructions.
Connection of the device must be done by a qualified
electrician.
Before the installation (dismantling) and connection
(disconnection) of the device, turn off voltage supply and
also act according to the «Rules of an arrangement of
electric installations».
Turning on and off or and configure the device should be
with dry hands.
Do not connect the device to the network disassembled.
Avoid hitting of water or moisture to the device.
Never clean the device with the use of chemicals such as
benzene, solvents.
Do not expose the device to extreme temperatures (higher
than 40 ºС or below -5 °C) and high humidity.
Do not store the device and do not use it in areas with the
dust.
Do not attempt to disassemble and repair the device.
Do not exceed the landmarks value adaptor and power.
To protect against overvoltage caused by lightning
discharges, use a lightning protector.
Protect the children from games with the working device, it
is dangerous.
ADDITIONAL INFORMATION
Date of manufacture is on the back side of device.
Application time is unlimited.
Do not fire and do not throw away the device with
the household waste.
The device does not contain harmful substances.
If you have any questions or you something will not clear,
call the Service centre the telephone number listed below.
Transportation of goods carried in the package, ensuring
the safety of the product.
After the end of its service life, the product must
be disposed of in accordance with applicable law.
The deive is transported by any kind of transport (rail, sea,
motor, air transportation).
POSSIBLE PROBLEMS, CAUSES
AND WAYS TO OVERCOME THEM