User Manual
Table Of Contents
- 1.Prepare
- 2.Insert the nano-SIM Card
- 3.Power on Your Device
- 4.Access the Internet
- 5.Change Your Device Settings
- Cable Broadband Mode
- Telephone
- WPS
- Indicator Lights and Interfaces
- Troubleshooting
- Getting More Help
- LEGAL INFORMATION
- Warning and Notice
- Safety Precautions
- Cleaning and Maintaining
- Limited Warranty
- Limitation of Liability
- FCC Regulations:
- Radio Frequency (RF) Exposure
- IC Notice
- IC Radiation Exposure Statement
14
Voice Related Problems
Symptoms
Possible Problems/ Solutions
There is no dial tone.
Please wait for 1~2 minutes after the router is turned on.
If the SIG indicator is weak, you have no good RF
reception. Change the location of the router.
There is a prompt / phone alert /
announcement as soon as I lift the
phone off the hook.
Make sure your nano-SIM card is inserted correctly and
the PIN number has been entered. If the PIN number has
been entered incorrectly, you need to enter the PUK code
when prompted.
The line is noisy/distorted when I lift the
phone off the hook.
Remove any electrical appliance which is too close
to the phone or your device.
The cable or phone set might be faulty.
I hear a rapid engaged tone as soon as
I lift the phone off the hook.
Put the phone on the hook and try again.
Please contact your service provider.
After dialing the last digit I hear
nothing/silence.
When you have finished dialing you can press the # key
or wait 4~8 seconds to connect the call.