User Manual

Version Number: ZS-CUT50DP-20210204A1

Precautions for power-on inspection:

1、 Please make sure your power supply voltage is 110V+-15% or 220+-15%. ZS-CUT50DP supports 110V and

220V input voltage in North America and Japan, and ZS-MICTEK ZS-CUT50DP supports 220V input voltage in

the UK, EU and other regions; if you have a generator power supply, please ensure that the generator is not less

than 6000w.

2、 It is recommended to choose 50A circuit breaker protection when your power supply voltage is 110V, and 30A

circuit breaker protection when 220V.

3、 For the current machine, please choose the power plug that suits your local electrical law requirements

4、 Extension cord: #12 AWG or larger; 25’ (8m) or shorter.

Turn on the power switch of the machine and the fan on the back of the machine rotates, and the digital display on

the panel indicates that the power is normal.

Note:

1) The digital display shows irregular changes at the beginning, and then returns to the digital display after 3

seconds, which is normal.

2) In order to reduce the working temperature of the machine, it is normal for the fan to continue to rotate for a

few seconds after the power is turned off.

3) During high-strength continuous welding, machine protection may occur. After continuous heat dissipation, the

machine will return to normal, which is normal.

Attached table: Self-examination of abnormal conditions without response when turning on the machine:

1. The machine's power switch is not turned on.

2. The power input voltage is wrong.

3. The power plug is loose.

4. The internal circuit is loose (due to long-distance transportation, bumps), you need to open the cover and

check the internal connection line.