User Manual

Version Number: ZS-CUT50DP-20210204A1
10
1. Clockwise increase air pressure 2. Pull up 3. Pull down 4. Air regulator 5. Air/Water filter
6. Water release 7. Anti-Clockwise Reduce air pressure
1.5 Adjust the current, only the current can be adjusted.
Possible problems:
1) There is no arc, check the ground wire to connect the workpiece to ensure that there is no rust, paint or other
coatings on the workpiece.
2) There is no arc, check the direct distance between the welding rod and the welding object, the ideal distance
is 1-2 mm; check whether the welding object has rust or oil stains, it is recommended to polish with sandpaper
or a grinder.
3) When welding, the spatter is very big, and it feels very difficult to weld. Please try to change the polarity
connection of the ground wire clamp and the welding clamp with the machine.
4) During the welding process, if the time exceeds 3 minutes, overcurrent protection may occur. You need to stop
working for a few minutes, let the machine cool down for a period of time, and automatically recover. If the air
cools for more than 10 minutes, the machine does not automatically recover, please shut down and restart.
5) If you have any problems that cannot be solved, please contact us at [e-mail] .
2 Cutting operation.
2.1 Start Cutting.
Hold the torch vertical at the edge Of
he work piece
Pull the trigger to start the arc ,The
cutting arc will initiate when the torch
tip is close enough to the work Piece.
Start cutting on the edge until the Arc
has cut completely through.
Then, Proceed with the cut.