User's Guide
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 First Time Installation
- 2
- 2.1 Overview
- 2.2 System Setup
- 2.3 Configuration Step by Step
- 2.3.1 Log into ZoneDAS
- 2.3.2 Set System Time
- 2.3.3 Ensure that RF Inputs are Within Range (0 ~ 24 dBm)
- 2.3.4 Configure BU Parameters
- 2.3.5 Loading a Pre-Set Configuration with a Config File
- 2.3.6 Checking RF Activity from the BU Screen
- 2.3.7 Mount Each RU
- 2.3.8 Configure RU Parameters
- 2.3.9 Turn Service On
- 2.3.10 Fill in Descriptive Information
- 2.3.11 Set Central Management
- 2.3.12 Save Settings
- 2.3.13 Backup Configurations
- CHAPTER 3 The Web Configurator
- CHAPTER 4 Home
- Chapter 5 Setting
- Chapter 6 Fault
- CHAPTER 7 System
- CHAPTER 8 Maintenance
Chapter 5: Setting
ZoneDAS User Guide Page | 38
The Advanced Settings Screen
Use the Advanced Settings screen to configure Auto Levelling for the BU. “Auto-Levelling” is
an intelligent algorithm that ZoneDAS uses to adapt to widely varying, unpredictable input
signal strengths. Through Auto-Levelling, ZoneDAS is able to maintain a stable and optimal
output signal pattern despite changes to input signal strengths from Base Transceiver
Stations. Default settings of this smart algorithm have been determined during extensive
field-operations and are adapted in function of technology and modulation schemes.
Click Setting > Advanced Settings to open the following screen.
Figure 31 Setting > Advanced Settings
Advanced Settings represent internal parameters that the system uses for signal
optimization. They are not meant for manual adjustment and it is recommended that the
user simply choose Use Defaults for all values. If for any reason you wish to adjust these
values, please consult Zyxel using the Customer Support contact information behind the
front page of this Guide.