User's Guide
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 First Time Installation
- 2
- 2.1 Overview
- 2.2 System Setup
- 2.3 Configuration Step by Step
- 2.3.1 Log into ZoneDAS
- 2.3.2 Set System Time
- 2.3.3 Ensure that RF Inputs are Within Range (0 ~ 24 dBm)
- 2.3.4 Configure BU Parameters
- 2.3.5 Loading a Pre-Set Configuration with a Config File
- 2.3.6 Checking RF Activity from the BU Screen
- 2.3.7 Mount Each RU
- 2.3.8 Configure RU Parameters
- 2.3.9 Turn Service On
- 2.3.10 Fill in Descriptive Information
- 2.3.11 Set Central Management
- 2.3.12 Save Settings
- 2.3.13 Backup Configurations
- CHAPTER 3 The Web Configurator
- CHAPTER 4 Home
- Chapter 5 Setting
- Chapter 6 Fault
- CHAPTER 7 System
- CHAPTER 8 Maintenance
Chapter 5: Setting
ZoneDAS User Guide Page | 35
CHAPTER 5
S
ETTING
Overview
The Setting menu is used to configure the BU and its connected RUs. Once you have set up
all the parameters in both the BU Settings and RU Settings screens, your ZoneDAS will be up
and running.
5.1.1 Available Functions
• Use the BU Settings screen to configure the BU’s connection settings (Section 5.2).
• Use the RU Settings screen to configure the RU’s connection settings (Section 5.3).
• Use the Advanced Settings screen to configure the system’s Auto Leveling settings
(Section 5.4).
The BU Settings Screen
Use the BU screen to configure the BU’s connection settings and allow ZoneDAS to properly
transmit/ receive information to and/from the operator’s BTS (Base Transceiver Station).
Click Setting > BU Settings to open the following screen.
Figure 29 Setting > BU Settings