User's Guide
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 First Time Installation
- 2
- 2.1 Overview
- 2.2 System Setup
- 2.3 Configuration Step by Step
- 2.3.1 Log into ZoneDAS
- 2.3.2 Set System Time
- 2.3.3 Ensure that RF Inputs are Within Range (0 ~ 24 dBm)
- 2.3.4 Configure BU Parameters
- 2.3.5 Loading a Pre-Set Configuration with a Config File
- 2.3.6 Checking RF Activity from the BU Screen
- 2.3.7 Mount Each RU
- 2.3.8 Configure RU Parameters
- 2.3.9 Turn Service On
- 2.3.10 Fill in Descriptive Information
- 2.3.11 Set Central Management
- 2.3.12 Save Settings
- 2.3.13 Backup Configurations
- CHAPTER 3 The Web Configurator
- CHAPTER 4 Home
- Chapter 5 Setting
- Chapter 6 Fault
- CHAPTER 7 System
- CHAPTER 8 Maintenance
Chapter 4: Home
ZoneDAS User Guide Page | 29
CHAPTER 4
Home
Overview
The Home screen is, as the name implies, the starting point from which everything is done in
the Web Configurator. As such, it is the screen that appears first after login. Use the Home
screen to monitor and configure the BU (Base Unit) and its connected Extenders / RUs
(Remote Units).
4.1.1 Available Functions
• View each system part’s connection status, perform a system-wide calibration, and
activate/deactivate service (Section 4.2).
• Access the BU screen to monitor the BU’s RF modules (Section 4.3).
• Access the RU screen to monitor the RU and its RF modules (Section 4.4).
The Home Screen
The Home screen’s primary function is to show a map of the system’s connections. The LED
lights on its illustrated devices are designed to match the physical lights on the actual
devices (albeit with some communication delays). The exception is when an RU is
configured for LED OFF, in which case the system turns off only the physical LEDs. Check
Section 1.3.2 and 1.3.3
for details on BU and RU LED signaling. To open the Home screen
from anywhere in Web Configurator, just click Home on the Navigation Panel (blue bar), as
shown below.
Figure 25 ZoneDAS Home Screen