User's Guide
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 First Time Installation
- 2
- 2.1 Overview
- 2.2 System Setup
- 2.3 Configuration Step by Step
- 2.3.1 Log into ZoneDAS
- 2.3.2 Set System Time
- 2.3.3 Ensure that RF Inputs are Within Range (0 ~ 24 dBm)
- 2.3.4 Configure BU Parameters
- 2.3.5 Loading a Pre-Set Configuration with a Config File
- 2.3.6 Checking RF Activity from the BU Screen
- 2.3.7 Mount Each RU
- 2.3.8 Configure RU Parameters
- 2.3.9 Turn Service On
- 2.3.10 Fill in Descriptive Information
- 2.3.11 Set Central Management
- 2.3.12 Save Settings
- 2.3.13 Backup Configurations
- CHAPTER 3 The Web Configurator
- CHAPTER 4 Home
- Chapter 5 Setting
- Chapter 6 Fault
- CHAPTER 7 System
- CHAPTER 8 Maintenance
Chapter 3: The Web Configurator
ZoneDAS User Guide Page | 26
Figure 21 Login screen
3.2.1 The Web Configurator Layout
The Web Configurator is arranged into these parts:
Figure 22 The Web Configurator Layout
A - Title Bar
B - Navigation Panel
C - Main Window
The RUs and/or Extenders shown below the BU are arranged in order of SD port connection,
top to bottom. The top RU is the one connected to the first SD port, labeled “RU1”, and the
bottom RU is the one connected to the last SD port, labeled “RU8”. Lines illustrating the BU-
RU and/or BU-Extender connections are for illustration only and stop at the BU, but the
physical cables do extend to the ports.
See Section 4.2 The Home Screen
to learn more about the different colors illustrating the
cable connections, plus the Web Configurator’s Home Screen.