User's Guide
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 First Time Installation
- 2
- 2.1 Overview
- 2.2 System Setup
- 2.3 Configuration Step by Step
- 2.3.1 Log into ZoneDAS
- 2.3.2 Set System Time
- 2.3.3 Ensure that RF Inputs are Within Range (0 ~ 24 dBm)
- 2.3.4 Configure BU Parameters
- 2.3.5 Loading a Pre-Set Configuration with a Config File
- 2.3.6 Checking RF Activity from the BU Screen
- 2.3.7 Mount Each RU
- 2.3.8 Configure RU Parameters
- 2.3.9 Turn Service On
- 2.3.10 Fill in Descriptive Information
- 2.3.11 Set Central Management
- 2.3.12 Save Settings
- 2.3.13 Backup Configurations
- CHAPTER 3 The Web Configurator
- CHAPTER 4 Home
- Chapter 5 Setting
- Chapter 6 Fault
- CHAPTER 7 System
- CHAPTER 8 Maintenance
Chapter 2: First Time Installation
ZoneDAS User Guide Page | 24
2.3.13 Backup Configurations
To backup current configurations to a file, select Maintenance from the Navigation Panel
and click on Config File. This opens the Config File screen, shown below. From the Config
File screen, click Backup and ZoneDAS will create a backup file in the default download
folder, using its Serial Code and Date as part of the file name.
Figure 20 The Config File screen
Once the backup config file has been created, be sure to keep a copy safe for future use.
Setting up a system via loading a config file would be far quicker than doing it again from
scratch.