User Guide

©2021, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
5
Food and beverages should be kept away from both the 3D printers and 3D printed objects.
While operating Zortrax devices, all measures regarding health and safety provided in this User
Guide as well as in separate regulations should be taken into account.
Electrical Safety
Zortrax 3D printers have been tested for compliance with Low Voltage Directive. In order
to ensure the highest safety standards, including protection against short circuit, overload,
overvoltage, and printer overheating, do not attempt to modify the printer and do not use
electronic replacement parts other than those recommended by the Manufacturer.
Replace electronic units according to the instructions and be particularly careful while using the
tools supplied with the printer.
Before plugging the power cable into the outlet, make sure that the power supply voltage in
the outlet matches the required value provided on the nameplate at the back of the printer.
Avoid overloading the outlet with too many devices.
The printer must be well-grounded. Always make sure that the ground complies with local and
national regulations.
Use only the original power cable supplied with the printer. Do not damage, cut, or repair the
cable. A damaged cable should be immediately replaced with a new one.
All maintenance and repair work should be carried out while the device is off and unplugged.
Do not expose the device to moisture and liquids. Modifications such as soldering of electronic
subunits are forbidden.
Mechanical Safety
Zortrax 3D printers have movable components, such as the drive belts, extruder, or
platform. Therefore, it is forbidden to reach into the printer or put anything inside the
printer when it is running, about to start running, or at rest. This may lead to serious
injuries or damage.
Tools and accessories from the Starter Kit box should be used with special care only for
intended purposes. Improper use of the tools may cause serious injuries.