User Guide

©2021, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
40
Material Loading
Open the Tools menu, and select Material and Load material. Next, select the material type
you are going to use. At this point the printer will start to heat up the extruder.
WARNING! The extruder will be hot. Don’t touch it. Wear safety gloves.
Once heating is completed, install the material spool on the spool holder at the back of
the printer, feed the material into the extruder through the material endstop and the
material guide.
Follow the instructions displayed on the screen.