User Guide

©2021, Zortrax S.A. All rights reserved. All trade names, logos and trademarks mentioned in the following
document are registered trademarks of Zortrax and are subject to legal protection.
3
Introduction
Read this User Guide carefully and thoroughly before operating Zortrax products for the
first time. The User Guide includes basic information about the 3D printer, safety and
protection guidelines as well as advice on preparing the machine for the first printing and
basic maintenance work. Ignorance and non-compliance with these instructions may result
in property damage, injuries, device failures, or lower quality of 3D prints. It is also necessary
to ensure that every 3D printer user knows, fully understands and follows the instructions
provided in this User Guide.
The Manufacturer makes every effort to ensure that Zortrax products are safe in transportation,
installation, usage, storage, and disposal. However, given the lack of direct and indirect control
over the device and a number of other factors influencing the device, the Manufacturer is not
responsible for damage, injuries, failures, and costs resulting from improper transportation,
installation, usage, storage, and disposal.
Furthermore, the users should take into consideration the risk of possible damage of the
device resulting from defects in material and workmanship.
Intended Use of Zortrax Printers
Zortrax 3D printers work in the Layer Plastic Deposition (LPD) technology, in which a previously
melted material is deposited on a surface layer after layer in order to form a predesigned
shape. The extruder is equipped with three heating points, which allows the melted material to
exit the nozzle and be deposited onto the heated platform without causing blockages.
The users are responsible for qualifying and determining the intended use of 3D printed
models. The Manufacturer takes no responsibility for any use of the printed objects, especially
when those objects constitute a part of safety equipment or strictly regulated medical, military,
or space science equipment.
Due to the size and specificity, Zortrax devices are not intended for use by children under
the age of 14 and by people with reduced manual, motor, and psychomotor skills. The
Manufacturer recommends providing assistance and guidance to people with disabilities and
older adults who wish to operate the printers.