User manual

Open the porthole and
remove the polystyrene
block fitted on the door
seal.
Fill the smaller upper
hole and the two large
ones with the corre-
sponding plastic plug
caps supplied in the bag
containing the instruction
booklet.
Positioning
Install the machine on a flat hard floor. Make sure that
air circulation around the machine is not impeded by
carpets, rugs etc. Check that the machine does not
touch the wall or other kitchen units. Level the washing
machine by raising or lowering the feet. The feet may
be tight to adjust as they incorporate a self locking nut,
but the machine MUST be level and stable.
Any necessary adjustment can be made with a span-
ner.
Accurate levelling prevents vibration, noise and dis-
placement of the machine during operation. Never
place cardboard, wood or similar materials under the
machine to compensate for any unevenness in the
floor.
If necessary, check the
setting with a spirit level.
Water inlet
Warning! This appliance must be connected to
a cold water supply
Caution! Before connecting up the appliance to
new pipework or to pipework that has not been
used for some time, run off a reasonable amount of
water to flush out any debris that may have collected
Caution! Do not use the hose from your previous
appliance to connect to water supply.
Connect the hose to a
tap with a 3/4” thread. Al-
ways use the hose sup-
plied with the appliance.
35°
45°
The other end of the inlet hose which connects to the
appliance can be turned as showed in the picture.
Do not place the inlet hose downwards. Angle the
hose to the left or right depending on the position of
your water tap. Set the hose correctly by loosening
the ring nut. After positioning the inlet hose, be sure
to tighten the ring nut again to prevent leaks.
Caution! The inlet hose must not be lengthened.
If it is too short and you do not wish to move the
tap, you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in three
ways:
Hooked over the edge
of a sink using the
plastic hose guide sup-
plied with the machine.
22