User manual

• Unscrew the hose from the machine. Keep a rag
nearby because some water may flow.
• Clean the filter in the valve with a stiff brush or
with the piece of cloth.
35°
45°
• Screw the hose back to the machine and make
sure the connection is tight.
• Turn on the water tap.
Frost precaution
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
• Turn off the water tap.
• Unscrew the inlet hose.
• Place the end of the emergency emptying hose and
that of the inlet hose in a bowl placed on the floor
and let water drain out.
• Screw the water inlet hose back on and reposition
the emergency emptying hose after having put the
cap on again.
• When you intend to start the machine up again,
make sure that the room temperature is above 0°C.
Emergency emptying out
If the water is not discharged, proceed as follows to
empty out the machine:
• pull out the plug from the power socket;
• close the water tap;
• if necessary, wait until the water has cooled down;
• open the pump door;
• place a bowl on the floor and place the end of the
emergency emptying hose into the bowl. Remove its
cap. The water should drain by gravity into the bowl.
When the bowl is full, put the cap back on the hose.
Empty the bowl. Repeat the procedure until water
stops flowing out;
• clean the pump if necessary as previously described;
• replace the emergency emptying hose in its seat af-
ter having plugged it;
• screw the pump cover again and close the door.
Important! Every time you drain the water through the
emergency emptying hose you must pour 2 litres of
water into the main wash compartment of the detergent
drawer and then run the drain programme. This will
activate the ECO Valve device avoiding that part of the
detergent remains unused at next washing.
What to do if ...
Certain problems are due to lack of simple mainte-
nance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local
Service Centre, please carry out the checks listed be-
low.
During machine operation it is possible that the red pi-
lot light of button 7 blinks, one of the following alarm co-
des appears on the display and some acoustic signals
sound every 20 seconds to indicate that the machine is
not working:
•
: problem with the water supply.
•
: problem with the water draining.
•
: door open.
Once the problem has been eliminated, press the but-
ton 7 to restart the programme. If after all checks, the
problem persists, contact your local Service Centre.
17