User manual

Pull out the emergency
emptying hose, place it in
the container and remove
its cap.
When no more water comes out, unscrew the pump
cover by turning it anti-clockwise and remove the fil-
ter. Use pliers, if necessary. Always keep a rag near-
by to dry up any water spillages when removing the
cover.
Clean the filter under a tap, to remove any traces of
fluff.
Remove foreign bodies
and fluff from the filter
seat and from the pump
impeller.
Check carefully whether the pump impeller rotates (it
rotates jerkily). If it doesn’t rotate, please contact your
Service Centre.
Put the cap back on the emergency emptying hose
and place the latter back in its seat.
Replace the filter into the
pump by inserting it cor-
rectly into the special
guides. Screw the pump
cover firmly by turning it
clockwise.
Close the pump door.
Caution! When the appliance is in use and
depending on the programme selected there can
be hot water in the pump.
Never remove the pump cover during a wash cycle,
always wait until the appliance has finished the cycle,
and is empty. When refitting the pump cover, ensure it
is securely re-tightened so as to stop leaks and young
children being able to remove it.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, takes long to fill
with water, the starting button blinks yellow or the
display (if available) shows the relevant alarm (see
chapter "What to do if..." for more details), check if the
water inlet filters are blocked .
To clean the water inlet filters:
• Turn off the water tap.
• Unscrew the hose
from the tap.
• Clean the filter in the
hose with a stiff brush.
• Screw the hose back onto the tap. Make sure the
connection is tight.
16