User manual

• Measure out the de-
tergent.
• Pour the powder de-
tergent into the main
wash compartment
.
• Remove the remaining powder form the flap.
• There is remaining powder detergent in the
main wash compartment at the end of a
washing programme. Check if the flap is in
the right position.
The flap is up and you wish to use liquid deter-
gent:
• Turn the flap down.
• Measure out the de-
tergent.
For the quantity of
detergent, refer al-
ways to what is written
on the product packing
and ensure that the de-
tergent can be poured in
the drawer.
•
Pour the liquid detergent in the compartment
without exceeding the limit indicated in the flap.
• Close the dispenser drawer.
Warning! Do not use the flap in "DOWN" position
with:
• Gelatinous detergent or thick detergent.
• Powder detergent.
• With programmes with prewash.
• Do not use liquid detergent if the washing pro-
gramme doesn't start immediately.
In these cases, use the flap in "UP" position .
Select the required programme by means of
the programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme.
The green pilot light of button 7 starts to flash. The se-
lector dial can be turned either clockwise or anticlock-
wise.
Turn the selector dial to position
to reset the pro-
gramme/to switch the machine OFF.
At the end of the programme the selector dial must
be turned to position
, to switch the machine
off.
Important! If you turn the programme selector dial to
another programme when the machine is working, the
red pilot light of button 7 will blink 3 times and the
messageErr is displayed to indicate a wrong selection.
The machine will not perform the new selected
programme.
Select the spin speed by pressing button 2
When selecting a programme, the appliance proposes
automatically the maximum spin speed provided for
that programme. (See "Washing programmes" for the
maximum allowed spin speed).
Press this button repeatedly to change the spin speed,
if you want your laundry to be spun at a different speed.
The relevant pilot light illuminates.
Select the available options by means of
buttons 3, 4, 5 and 6
Depending on the programme, different options can be
combined. These must be selected after choosing the
desired programme and before starting the programme.
When these buttons are pressed, the corresponding pi-
lot lights illuminate. When they are pressed again, the
pilot lights go out. If an incorrect option is selected, the
integrated red pilot light of the button 7 flashes 3 times
and the message Err is displayed.
For the compatibility among the washing programmes
and the options see chapter «Washing programmes».
Start the programme by pressing button 7
To start the selected programme, press this button; the
corresponding green pilot light stops blinking.
The pilot light 9 illuminates to indicate that the appli-
ance starts operating and the door is locked.
If you have chosen a delayed start, the machine will be-
gin the countdown.
13