User`s guide

76 | P a g e
c. After the LED stops flashing, press the short the LRN pins again to select the next relay channel
d. Repeat step c until the required output relay is selected.
2. Press the button on the transmitter you want to learn to the relay output.
3. The Learn LED will then illuminate, press the same transmitter button again.
4. The Learn LED will then flash to indicate learning is complete.
5. To test the operation, press the transmitter button again and you will hear the relay ‘click’ as it operates.
COM
NO
NC
Relay Connections when
Transmitter NOT Operating
COM
NO
NC
Relay Connections when
Transmitter OPERATING
LEARN
OPTION LINK1
OPTION LINK2
OPTION LINK 3
SERIAL DATA OUT
Downloaded from Elcodis.com electronic components distributor
DSWASP-1 Feb 09 2009 Page 3
WASP HIGHLY SECURE REMOTE CONTROL SYSTEMS
Erasing Receivers Memory
1. Short the LRN (Learn) pins for approx 10 seconds.
2. When the Learn LED turns OFF all memory is erased
3. This is factory default state which is indicated by all output LED’s flashing together.
NOTE: You cannot erase individual Tx encoders
Technical Specifications
Transmitter Keyfob
Battery Type GP23AE (supplied)
Electrical Characteristics Min Typical Max Units
Supply Voltage 8.5 9 16 Vdc
Supply Current : Quiescent 0 mA
Supply Current : Transmitting 8 mA
Operating frequency 433.92 MHz
Receiver Decoder
Dimensions 96mm x 55mm x 29mm
ELECTRICAL CHARACTERISTICS MIN TYPICAL MAX DIMENSION
Supply Voltage for +12Vdc
for +24Vdc
11
23
12
24
13
25
Vdc
Vdc
Supply Current: Quiescent
All relays operating
14
140
mA
mA
[e-mail] www.quasaruk.co.uk
Downloaded from Elcodis.com electronic components distributor