User manual


84
Figure 27. Example of Radio Page
Table 22. Radio Menu Option
Option Description
Wireless Interface
This is the MAC address of the wireless interface.
Wireless
Select Enable to enable the wireless function.
Country
Your device is configured for operation in the U.S. only.
Output Power
Set the strength of the wireless signal that the Cable
Modem/Router transmits.
802.11 Band
Your device supports 2.4 GHz only.
802.11n-mode
In Auto mode, your Cable Modem/Router will automatically
adjust to avoid interference with neighboring devices.
Bandwidth
Specify radio frequency bandwidth, either 20MHz single, or
40MHz (dual channel), that the Cable Modem/Router will use if
802.11n mode is configured as Automatic and the Control
Channel is configured as Automatic.
Sideband for
Control Channel
(40 MHz only)
You may select Sideband and the secondary extension
channels if your Cable Modem/Router is operating at 40 MHz
bandwidth and the 802.11n-mode is configured as Auto.
Control Channel
Select the channel for AP operation next to the drop-down list
box. The current channel number is displayed. The list of
detailed control channel and extension channels are shown in
the Table below.