User manual

Move “Active Frame” to “PTZ Linkage” button, press [ENTER] key to enter

“PTZ Linkage” setup menu: Shown as Fig.5.25 below.

Fig. 5.25 PTZ linkage setup

First select one camera, and then select one of following PTZ linkages:

 Preset: Set the flag as “” to enable preset, in the preset number edit box and

input one preset number that has been setup already. Please refer to chapter

5.15 for preset setup.

 Sequence: Set the flag as “” to enable sequence and input one sequence

number that has been setup already. Please refer to chapter 5.15 for sequence

setup.

 Cruise: Set the flag as “” to enable cruise. Please refer to chapter 5.15 for

cruise setup.

Press “Confirm” button to save and return “Alarms” menu. Press “Cancel” button

or [ESC] key to abort and return “Alarms” menu.

Note: Please make sure that the PTZ you are using can support preset,

sequence and cruise functions. One external alarm input can trigger many

cameras PTZ linkage.

Step 9: Copy the parameters to other external alarm input

You can copy the parameters of current alarm input to other external input.

Step 10: Save setup

In “Alarms” menu, press “Confirm” button to save the parameters. Press

“Cancel” button or [ESC] key to abort.

Alarm relay output setup

Step 1: In “Alarms” menu, use [↑] [↓] keys to select one alarm output.

Step 2: Select delay time

The delay time is when the alarm is disappeared; the alarm output will continue