User`s manual

Chapter 2: Installing Your Cable Modem 9
Installing the Software—USB
Users Only
Important!
This section is only for Windows computer users who need to use
the cable modem’s USB port.
Windows computer users who are using the USB option
MUST install the software BEFORE installing the hardware.
Note, however, that you must remove any existing USB modem
drivers on your Windows computer before beginning this software
installation. On the desktop, click the Start button, and then—
depending on your operating system—either click Control Panel,
or click Settings and then Control Panel. In the Control Panel,
double-click Add/Remove Programs. On the Add/Remove
Program Properties dialog box, select the USB modem you are
removing on the Install/Uninstall tab, click Remove, and then
click OK.
1
11
1 Turn on the computer that you want to use to connect to the
Internet.
2
22
2
Insert the supplied CD into the CD-ROM drive of your
computer. The CD should start automatically. (If the CD does
not start automatically, on the desktop, click the Start button,
click Run, and then type D:\setup.exe, where D is the letter
of your CD-ROM drive.)
3
33
3 Click Installation Wizard.
4
44
4 Click Next when prompted.
5
55
5 When the installation is complete, click Finish, then click
Exit.