Specifications

About projects
ZOOM PS-04 97
2. Turn the dial to select the copy
destination project number, and
press the [ENTER] key.
The indication “ENT/EXIT” appears on the display.
3. To carry out the copy operation,
press the [ENTER] key once more. To
cancel the operation, press the
[EXIT] key.
When you carry out the copy operation, the copy
destination project is loaded, and the AUDIO mode
top screen appears.
■ Deleting a project
You can delete a project from the SmartMedia card
as follows.
N OTE
Once a project has been deleted, it cannot be
restored. Use this function with care, to avoid
losing a project that you want to keep.
1. Refer to “Basic steps for handling
projects” and bring up the indication
“DELETE”. Then press the [ENTER] key.
The following screen appears.
2. Turn the dial to select the project
number, and press the [ENTER] key.
The indication “ENT/EXIT” appears on the display.
3. To carry out the delete operation,
press the [ENTER] key once more. To
cancel the operation, press the
[EXIT] key.
It is also possible to delete the currently loaded project.
In this case, the immediately preceding project will be
automatically loaded.
N OTE
A project for which write-protect (see next
section) has been enabled cannot be deleted.
■ Protecting a project
You can write-protect the current project, so that its
contents cannot be changed.
A write-protected project can be played as usual,
and you can change any of the settings, but the
changes cannot be stored on the SmartMedia card.
It is highly recommended to use this function for
protecting a completed project from accidental
overwriting or erasure.
1. Refer to “Basic steps for handling
projects” and bring up the indication
“PROTECT”. Then press the [ENTER] key.
The display changes as follows.
2. Turn the dial to change the setting to
“ON”.
Write-protection is enabled and you can no longer
store any changes to the current project. To turn off
write-protection, call up the above screen again and
change the setting to “OFF”.
3. Press the [EXIT] key repeatedly to
return to the original screen.
Each press of the [EXIT] key goes back by one
screen.
■ Checking the remaining
recording time
To verify how much recording time is left on the
SmartMedia card, proceed as follows.
1. Refer to “Basic steps for handling
TO
TO
03
03
Copy destination project number
Number of project to delete
PROJO1
PROJO1
01
Protect on/off setting
PRTCT
PRTCT
0FF