Specifications

Basic steps for using the send/return effect
ZOOM PS-04 91
3. Use the cursor up/down keys to
select the effect type.
For details on effect types that can be selected for
the send/return effect, see the list in the last section
of this documentation.
4. Use faders 1 – 4 to adjust the
parameter setting value.
When you move a fader, the respective parameter
value is shown for a few seconds on the display.
The level meters give a rough indication of the
value. For a list of parameters that can be adjusted,
see the list in the last section of this documentation.
H INT
• When you press the status keys 1 – 4, the
value of the corresponding effect parameter is
shown. In this condition, the dial can be used
to adjust the displayed parameter value.
• For send/return effects, parameters are shown
on two pages. (The currently shown page is
indicated by P1/P2. If necessary, use the
cursor left/right keys to select the page, and
then use the faders to make the adjustment.
5. Repeat the above procedure as
necessary to adjust other parameters.
6. When the settings are complete,
press the [EXIT] key.
The send/return effect top screen returns.
N OTE
If you switch to another patch without first
saving the edited patch, all changes will be lost.
See the next section for information on how to
store a patch.
■ Storing a send/return effect
patch
To retain an edited patch, proceed as follows.
1. From the send/return effect top
screen, press the [EDIT/UTILITY] key
and edit the patch.
2. When patch editing is complete, press
the [INSERT/DELETE (COPY)] key.
The store target patch number and the name of the
currently selected patch are shown alternately on
the display.
3. Turn the dial to select the number in
which to store the patch.
4. To carry out the store operation,
press the [ENTER] key.
The edited patch is stored, and the send/return
effect top screen returns.
■ Changing a send/return effect
patch name
The name of the currently selected send/return
effect patch can be changed as follows.
1. From the send/return effect top
screen, select the patch whose name
you want to change, and press the
[EDIT/UTILITY] key.
Effect type name
HALL
HALL
P1
ROOM
ROOM
PI
PREDLY
PREDLY
8
Effect parameter name
Parameter setting value
Rough indication of parameter setting
STORE)STORE)
2