Specifications
Quick Guide
20 ZOOM PS-04
H
INT
• When the built-in mic is selected as recording source, the [MIC] key lights up. You can
also select the built-in mic by pressing the [MIC] key from the AUDIO mode top screen.
(In this case, there is no need to call up the above track parameter screen.)
• If desired, you can also combine multiple input sources (
→ p. 53).
• When the built-in mic can be used, the [MIC] key is flashing.
• When the insert effect algorithm is "GUITAR/BASS", the built-in mic cannot be used
(except when the effect type "CABI" is selected on the PRE AMP/DRIVE module or when
it is turned off). In this case, the "REC" indication for the built-in mic is out.
3.
When the [INPUT] jack has been selected as input source, play the instrument
connected to the jack and adjust the input sensitivity by turning the [INPUT
LEVEL] knob on the rear panel of the PS-04.
When using the [INPUT] jack, adjusting the input sensitivity with the
[INPUT LEVEL] knob is necessary. Make the adjustment so that the sound is
not distorted when playing the instrument at maximum level. (If the
indication "-PEAK-" is shown on the display, signal distortion has occurred.)
H
INT
• When the built-in mic is selected as input source, two gain settings (on-mic/off-mic) are
available. The default is on-mic, but this can be changed if desired (
→ p. 99).
• When the [LINE IN] jack is selected as input source, adjust the output level of the source
equipment so that there is no distortion in the input stage of the PS-04.
4.
While playing the instrument, operate the fader for the input source to adjust
the recording level.
While one of the above screens is being shown, faders 1 – 4 can be used to adjust the recording
level for each recording source. When you move a fader, the current setting value is shown on the
display. A rough indication of the setting for each source is given by the level meter segments.
INPUT
INPUT
LINE
LINE
MIC
MIC
When built-in mic (status key 1) is selected When [INPUT] jack (status key 2) is selected
When [LINE IN] jack (status key 3 or 4) is selected