Specifications

Effect Parameters
ZOOM PS-04 107
Table 3: TYPE
Table 4: R MODE
Table 5: R WAVE
Table 6: R SYNC
● TOTAL module
MIC algorithm
● COMP module
R WAVE
Table 5 Selects the control waveform type.
R SYNC
Table 6 Adjusts the control waveform cycle
1 Semitone lower→ original pitch 9 1 octave lower + original pitch→ 1 octave higher + original pitch
2 Original pitch→ semitone lower 10 1 octave higher + original pitch→ 1 octave lower + original pitch
3 Doubling→ detune + original pitch 11
Perfect fifth lower + original pitch→ perfect fourth higher + orig-
inal pitch
4 Detune + original pitch→ doubling 12
Perfect fourth higher + original pitch→ perfect fifth lower + orig-
inal pitch
5 Original pitch→ 1 octave higher 13 0 Hz + original pitch→1 octave higher
6 1 octave higher→ original pitch 14 1 octave higher→ 0 Hz + original pitch
7 Original pitch→ 2 octaves lower 15 0 Hz + original sound→ 1 octave higher + original pitch
8 2 octaves lower→ original pitch 16 1 octave higher + original sound→ 0 Hz + original pitch
OFF Frequency stays constant
UP Minimum→ maximum
dn Maximum→ minimum
Hi Setting value→ maximum
Lo Minimum→ setting value
1 Rising sawtooth wave 5 Triangle wave
2 Rising fin wave 6 Second power triangle wave
3 Falling sawtooth wave 7 Sine wave
4 Falling fin wave 8 Square wave
05 Eighth note b1 1 measure
1 Quarter note b2 2 measures
2 Half note b3 3 measures
3 Dotted half note b4 4 measures
TYPE Parameter
PATLVL
Adjusts the patch volume level.
PATLVL
ZNR
Cuts noise during performance pauses.
ZNR
Parameter Setting range Description
PATLVL
1 - 30 Adjusts the patch volume level.
ZNR
OFF, 1 - 30 Adjusts the sensitivity.
TYPE Parameter
COMP
Keeps the dynamic range consistent.
THRESH RATIO ATTACK LEVEL
LIMIT
Controls the signal peeks.
THRESH RATIO RELEAS LEVEL