Manualshelf

Specifications

ManualsBrandsZoom ManualsMusic PedalPro 4040
12345678910
• Turn off the amplifier and set the volume control to
minimum. Then connect the 4040 to the instrument
and amplifier.
• Turn on the 4040 and then the amplifier. Adjust the
volume to a suitable position while playing the
instrument.
Panel display in Play mode
When the 4040 is turned on, it goes into Play mode
automatically. In the Play mode, the following information
is shown on the display.
(1) Group
The currently selected group is shown in the GROUP
field.
(2) Bank number
The currently selected bank number is shown in the
BANK field.
(3) Patch number
The currently selected patch number is indicated by the
pedal LED (1 - 4).
(4) Effect module on/off
The effect module on/off condition in the patch is
indicated by the module cursor LED.
Selecting a patch
• Select the desired group with the GROUP key.
In the 4040, patches are divided into the USER group for
patches which can be created and altered freely and stored
by the user, and the PRESET group for factory defined
patches where only the output level can be changed, but not
stored. Choose the group from which you want to select a
patch.
With each push of the GROUP key, the group setting cycles
through the following three settings which are shown on the
display.
• U (USER) USER group only
• P (PRESET) PRESET group only
• U. or P. (BOTH) USER group and PRESET group
7
Playing a Patch (Use of the Play Mode)
In the Play mode, a patch is selected and played. This section describes the basic operation steps for selecting patches.