Instruction manual

Immediately after booting, a dialog box

indicates that new hardware has been found

Insert the installation diskette for your operating

system in the floppy drive and select the

button. Verify that the

A: drive

is in the search

path and follows the prompts.

4. Run the

Setup***.exe Program

on the

installation diskette.

5. Reboot the computer.

NT 4.0

1. Before turning on the computer, verify that all

hardware (camera, cables and capture card) has

been installed according to the directions.

2. Start the computer.

3. Insert the installation diskette for your operating

system in the floppy drive. Run

Setup.exe

4. Reboot the computer.

Basic Operation

0. Before proceeding, verify that all hardware is

properly connected. Verify that the

camera is

powered on. Note the power LED located in the

front of the

PTZ Camera

. The

Zoom Camera

has a power LED on the back of the unit. Verify

that the

flash unit

is switched on and the charge

indicator LED is illuminated