Instruction manual

4
Quick Start hardware installation
NOTE: All cable connectors and matching
receptacles have been color coded for easy
installation
1. Install the VideoVue PCI capture card in an
available PCI slot. You must use the VideoVue
PCI image capture card that was shipped with
the VALCam ID system. Secure the back plate
of the card with a screw to the computer chassis.
2. Install the small
flash accessory
card on an
available back plate slot in the computer. Note
that this card does not have any slot fingers and
can be installed in any available slot. Secure the
back plate of the card with a screw to the
computer chassis.
Connect the male end of the split power cable on
the flash card to an available female connector
on from the computer power supply. This
connector can only be attached in the correct
orientation.
Verify that the Photo-Flash switch is in the
Yes
position.
3. Locate the
flash jumper
cable. This cable will
have
violet
and
blue
marks on the ends. Plug
the
violet
connector into the matching
violet
receptacle on the VideoVue PCI image capture
card.
Plug the
blue
end of the cable to the matching
blue
receptacle on the
flash
card.