Instruction manual

17
5. Adjust the
Color Level
control for optimal color
intensity. If this value is too low, images will
appear pale. If this value is too high colors will
appear too intense.
Some printers can distort color reproduction if
the color intensity too high.
The default value is
110
for
flash
captures and
is recommended in most cases.
Note: These changes are only seen after the capture
is taken. No change will be visible in the preview
window.
6. The extreme ranges of this control will change
the image from Green to Red. The default value
for flash captures is
40
and is recommended in
most cases.
Note: These changes are only seen after the capture
is taken. No change will be visible in the preview
window.
7. Adjust the
Cam Sharp
control for optimal image
sharpness. Usually a value between
6
and
15
will result in the best image. Its recommended to
print cards at different Cam Sharp levels to
determine the best value.
A value of
7
is default.
Note: A higher value might be needed for the best
print results as opposed to the best image on the
monitor.
Note: This control is only available on the latest
versions of the VALCam hardware
8. Click the
Restore Defaults
button to reset all
controls to their default settings.