Instruction manual

16
Note:
It is always recommended to zoom in as tight
as your image composition will allow for the highest
image quality.
1. Click the
Capture
button on the main dialog. The
camera will momentarily go dark and the flash
will fire.
2. If the capture is too light click the button one
or more times.
If the capture is too dark click the button one
or more times.
3. Click the
Capture
button again and repeat the
above process until the image brightness is
optimal. Usually a
Flash Iris
setting between
15
and
24
will be used. The higher the number the
brighter the captured image.
This value will not change unless the distance
between the camera and subject is increased or
decreased
Remember: When using the Flash these changes are
only viewed after the capture is taken. No change
will be visible in the preview window
.
4. Adjust the
Red
and
Blue
controls.
If the image is yellow increase
Blue
and
decrease
Red.
If the image is green increase
Red
and increase
Blue
.
The default is
0
for both
Red
and
Blue.
Note: These changes are only seen after the capture
is taken. No change will be visible in the preview
window.
Note: These controls are only available on the latest
versions of the VALCam hardware
.