Operation Manual

92
Troubleshooting
There is no sound or output is very quiet
• Check the speaker connections and vol-
ume settings on the speakers.
• Check instrument and mic connections
• When using a condenser mic, turn
on.
• Confirm that the SIG indicators are lit
green.
• Conrm that
is unlit.
• Raise all the channel faders and the mas-
ter fader, and conrm that the level meters
are lit.
• Conrm that the MASTER
is unlit
and is lit red.
Recorded audio is too loud, too quiet or
silent
• Adjust input gains and confirm that SIG
indicators are lit green.
• When using a condenser mic, turn
on.
• When recording to an SD card, confirm
that
is lit red.
Recording not possible
• When recording to an SD card, confirm
that
is lit red.
• Conrm that the SD card has open space.
• When recording to an SD card, confirm
that the project is not protected (to pre-
vent overwriting).
Playback sound cannot be heard or is
quiet
• When playing data from an SD card, con-
rm that
is lit green.
• Raise the faders on the playback channels,
and conrm that the level meters are lit.
The sounds of devices connected to
input jacks are distorted
• Conrm that SIG indicators are not lighting
red. If they are lighting, lower their input
gains. You can also turn on.
• Conrm that level meters are not lighting
to their highest levels. If a level meter is
lighting to its highest level, lower its fader.
The send effect is not working
• Conrm that the EFX RETURN is unlit.
• Raise the EFX RETURN fader, and conrm
that the EFX RETURN level meters are lit.
• Conrm the send amounts of the channels
on which you want to use the effect.
There is no sound or output is very quiet
from MONITOR OUT A–E
• Conrm the mixes of each output.
• Confirm that the output volume of each
output is raised (MONITOR OUT A
PHONES and MONITOR OUT A–E knobs).
• Confirm the settings of the MONITOR
OUT A–E switches.
General