User Manual

Selection of input source
When you select an input the corresponding
button lights, conrming the selection. To
turn off the input, press the corresponding
button so the light turns off.
To monitor input signals, you must turn
MONITOR on.
Note: If no input is selected and no input buttons are
lit, no signal is being sent to the computer.
032
Setup / Using as a USB audio interface
Adjust input and output levels
Open MENU and make settings
These buttons are usable
during setting
Button operation in AUDIO I/F menu
Press.
Select
and press.
AUDIO I/F MENU
EFFECT Useeects(only44.1kHz)
TUNER Use tuner
MONITOR Enable monitoring
PHANTOM Enable phantom power
PLUG-IN Enable plug-in power
DISCONNECT End connection
NOTE:
• You cannot change the sampling
rate while the computer identies
the H4n Pro as an audio interface.
• When connecting as an interface,
make sure the sampling rate (step
6) matches the recording software
and playback le.
• You cannot changed this setting
during recording and playback.
HINT:
Audio interface use
• You can record and playback
signals directly to and from your
DAW software using the H4n Pro.
• In this mode, you can use the
H4n Pros built-in eects on input
signals if the sampling rate is set
to 44.1kHz.
• No specic driver is needed to
use the H4n Pro as a USB audio
interface.
• When using a DAW or other soft
-
ware, refer to its manual.