User Manual

146
Reference / MTR mode eect types and parameters
RvsDelay This delay supports long delay times of up to 2500 ms.
(1) TIME
10–2500 ms,* ♪
(See P.146)
Sets the delay time.
(2) FEEDBACK 0–100
Adjusts the amount of feedback.
(3) HIDAMP 0–10
Adjusts the damping of high frequencies in the
delay sound.
(4) MIX 0–100
Adjusts the amount of eect sound mixed with
the original sound.
*milliseconds
HALL This reverb simulates the acoustics of a concert hall.
ROOM This reverb simulates the acoustics of a room.
SPRING This is a spring reverb simulation.
ARENA This simulates the acoustics of an arena-sized venue.
T ROOM This simulates the acoustics of a tiled room.
M SPRING
This is a spring reverb simulation with a bright and clear
tone.
The6eectsabovehavethesameparameters.
(1) DECAY 1–30
Sets the reverb duration.
(2) PRE DLY 1–100
Sets the time between when the original sound is
input and reverb starts.
(3) TONE 0–10
Adjusts the tone.
(4) MIX 0–100
Adjusts the amount of eect sound mixed with
the original sound.
Note durations
Parameters with ♪ values allow you to make settings in note units
based on the metronome tempo. The lengths of the notes are as
follows.
Thirty-second
note
Sixteenth note
Eighth note
Dotted eighth
note
Half note
triplet
Quarter note
x 3
Quarter note
triplet
Quarter note
Dotted six-
teenth note
Dotted
quarter note
Quarter note
x 2
Quarter note
x 20
x 2 x 20
x 33
3
NOTE
· The note values that can be selected depend on the parameter.
· Certain combinations of tempo and note values could exceed
parameter ranges. If this occurs, the value will be halved or even
quartered to achieve the allowed range.