Manual

Chapter 1: Installing the Game Point! 9
9
99
9 When a confirmation message appears, click
OK
to change the
operating mode. Another message will appear letting you know
that it may take a few moments while the unit resets itself and
changes its mode. Click
OK
. (Once the Game Point! reboots
itself, you will be prompted to log into the
Web Management
Interface
again.)
10
1010
10 Click
Wireless
in the left navigational menu, then click
Site Survey
. The page that opens lists the wireless
networks detected by the Game Point!. Click the
SSID
of
the network you want to be part of, then click
OK
when
asked to confirm this choice.
11
1111
11
Game Point! works well with networks that have WEP
security or no security, and does not work with networks
that have WPA security turned on. If the wireless network
you just selected has no security enabled, continue at step
12. If the wireless network you just selected has WEP
security, click
WEP Configuration
in the left navigational
menu. Specify the same WEP security settings as the
network, then click the
Save Changes
button. This will
allow your Game Point! to access the wireless network. (If
you need more detailed information about setting security,
see
Chapter 2: Setting Security
on page 11).
12
1212
12 Click the
Logout
icon at the top right of the screen, then
close your Web browser.
13
1313
13 Reset the computer’s
TCP/IP
settings to what they were
before you changed them.
14
1414
14 Test that your Game Point! is set up properly. Shut down
your PC and power it off. Power it back on. Open your
Web browser and go to a familiar site. If the Game Point!
is set up properly, you should be able to browse the Web.