Effect Types and Parameters

2 3
Effect Types and Parameters
G1
FOUR
/ G1X
FOUR
[ DYNAMICS ]
Comp This compressor in the style of the MXR Dyna Comp.
Sense Adjusts the sensitivity of the effect.
0 –10
ATTCK Sets compressor attack speed to Fast or Slow.
SLOW, FAST
Tone Adjusts the tone.
0 – 10
VOL Adjusts the volume.
0 – 100
RackComp This compressor allows more detailed adjustment than Comp.
THRSH Sets the level that activates the compressor. 0 – 50
Ratio Adjusts the compression ratio. 1 – 10
ATTCK Sets compressor attack speed. 1 – 10
VOL Adjusts the volume. 0 – 100
SlowATTCK This effect slows the attack of each note, resulting in a violin-like performance.
Time Adjusts the attack time. 1 – 50
Curve Set the curve of volume change during attack. 0 – 10
Tone Adjusts the tone. 0 – 100
VOL Adjusts the volume. 0 – 100
ZNR
ZOOM's unique noise reduction cuts noise during pauses in playing without affecting
the tone.
DETCT Sets control signal detection level.
GTRIN,
EFXIN
Depth Sets the depth of noise reduction. 0 – 100
THRSH Adjusts the effect sensitivity. 0 – 100
Decay Adjust the envelope release. 0 – 100
MuteSW This effect allows you to mute the volume using the foot switch.
★
Edge
Sets how smoothly the volume changes. As the parameter value increases, the change
becomes smoother.
0 – 100
Speed Adjust the recovery time from muting. 0 – 100
INVRT Sets the foot switch control direction.
NORMAL,
INVERT
ON/OFF
Sets the foot switch function.
LATCH,
UnLATCH,
TRGGR
GrayComp This models a ROSS Compressor. Added parameters allow you to adjust the tone.
SUSTN Adjusts the sustain. 0 – 100
Lo Adjusts volume of low frequencies. 0 – 100
Hi Adjusts volume of high frequencies. 0 – 100
VOL Adjusts the volume. 0 – 100
NoiseGate This is a noise gate that cuts the sound during playing pauses.
★
DETCT Sets control signal detection level. GTRIN, EFXIN
Depth Sets the depth of noise reduction. 0 – 100
THRSH Adjusts the effect sensitivity. 0 – 100
Decay Adjust the envelope release. 0 – 100
OptComp This is an optical compressor.
★
Drive Adjusts the depth of the compression. 0 – 10
Lo Adjusts volume of low frequencies. 0 – 100
Hi Adjusts volume of high frequencies. 0 – 100
VOL Adjusts the volume. 0 – 100