Specifications

Troubleshooting

● No sound or very little sound is output.

・ Conrm that the device and PC are connected via the USB cable.

・ Properly connect the guitar to the INPUT terminal, and the headphone to the PHONE (or OUTPUT) terminal.

・ Conrm that the shielded cable you are using works normally.

・ To adjust the sound volume, turn the [PATCH LEVEL] knob in Edit&Share.

・ Adjust the [Gain] parameter and [Level] parameter of the ampliers and e󰮏ectors used in Edit&Share.

・ You can use the expression pedal to adjust the sound volume of certain patches. Adjust the pedal to achieve the appropriate sound

volume.

・ Adjust the master level of the device.

・ Check the device settings.

● Noise stands out.

・ Lower the [Gain] parameter and [Level] parameter of amplier heads and drive e󰮏ectors used in Edit&Share.

・ Check the expression pedal settings. Depending on parameters assigned for the expression pedal, extreme changes to parameters

caused by operating the pedal may result in noise.

・ Make sure to check your peripheral equipment. Deteriorated, broken, or dirty connector terminals on the guitar or shielded cable may

result in adverse performance.

● The USB terminal is not recognized when it is connected to the PC.

・ Conrm that the OS supports the product.

● The e󰮏ector does not work.

・ Conrm that the e󰮏ector is turned on (LED is lit.) Edit&Share screen.

・ Check whether the device has been bypassed.

● Device does not get recognized correctly

・ When the device list is inproper, click the [Device]-[Connect]-[Refresh] menu to update the list.

● The device does not reply to Edit&Share while editing.

・ Please restart Edit&Share if you computer have turned into sleep mode.

(Edit&Share does not support sleep mode. Please do not use sleep mode.)