Specifications

62
Troubleshooting
Troubleshooting
No sound or very low volume
• Confirm that the POWER switch is set to
“O N”.
•Checktheconnections(→P4–5).
•Adjustthepatchlevel(
→P18).
•Adjustthemasterlevel(
→P20).
•
When adjusting the volume with the
Z-Pedal / an expression pedal, make sure
that a suitable volume setting has been set
with the pedal.
•Confirm that unit is not in mute mode
(→P24).
There is a lot of noise
•Checkshieldedcablesfordefects.
•UseonlyagenuineZOOMACadapter.
The sound distorts strangely/has an odd timbre
•SettheOUTPUT parameter accordingto
the output equipment (→P23).
•SettheACTIVE/PASSIVEswitchaccording
to the type of guitar pickups or the device
connected directly to the
(→P5).
•If you are using the TUBE BOOSTER,
lower the Boost level. (
→P34).
An effect is not working
• If the effect processing capacity is
exceeded, “ DSP FULL ” appears on the
effect graphic. In this case, the effect is
bypassed (→P10) .
The Z-Pedal is not working well
•ChecktheZ-Pedalsettings(→P12).
•AdjusttheZ-Pedal(
→P38).
The recorded level in a DAW is low
•Checktherecordinglevelsetting(→P22).