Specifications

59
NEXT
Z-Pedal Effect Types and Parameters
Z-Pedal Effect Types and Parameters
#1 VolBoostZ This effect provides a clean boost without changing frequency characteristics.
Knob1 Knob2 Knob3
Page01
VPosi 0–100
P HPosi L100–CNTR–R100 P Curve
Slow1,Slow2,
NRML,Fast
Sets the starting position value.
After the pedal is moved, the actual
position value is used.
Sets the starting position value.
After the pedal is moved, the actual
position value is used.
Selects the type of curve used for
vertical adjustments.
Page02
LEFT 10–300 CNTR 10–300 RIGHT 10–300
Sets the volume when pushed all
the way left.
Sets the volume when in the center
position.
Sets the volume when pushed all
the way right.
Page03
Level 0–150
Sets the output level.
#2 Filter-Z The cut-off frequency and resonance of this filter effect can be controlled using the pedal.
Knob1 Knob2 Knob3
Page01
Freq 0–100
P Reso 0–100 P Bal 0–100
Sets the cut-off frequency. Sets the resonance of the filter.
Sets the balance between source
and effect sounds.
Page02
Level 0–150
Sets the output level.
#3 Tremolo-Z The depth and rate of this tremolo effect can be controlled using the pedal.
Knob1 Knob2 Knob3
Page01
Depth 0–100
P Rate 0–100 P Level 0–150
Sets the modulation depth. Sets the modulation speed. Sets the output level.
Page02
Wave
UP 0–UP 9,
DWN 0–DWN 9,
TRI 0–TRI 9
PSync OFF,ON
Sets the waveform used for
modulation.
When ON, the rate value adjusted
by pedal horizontal operation will be
synchronized to tempo.
#4 Flanger-Z The mix and rate of this flanger effect can be controlled using the pedal.
Knob1 Knob2 Knob3
Page01
Mix 0–100
P Rate 0–100 P Depth 0–100
Sets the volume of the effect
compared to the source sound.
Sets the modulation speed. Sets the modulation depth.
Page02
PreD 0–50 PSync OFF,ON Level 0–150
Sets the pre-delay time of the effect
sound.
When ON, the rate value adjusted
by pedal horizontal operation is
synchronized to tempo.
Sets the output level.
#5 Echo-Z The time and feedback of this echo effect can be controlled using the pedal.
Knob1 Knob2 Knob3
Page01
Time 50–650
P F.B 0–100 P Mix 0–100
Sets the delay time. Sets the feedback amount.
Sets the volume of the effect
compared to the source sound.
Page02
HiDMP 0–10 PSync OFF,ON Level 0–150
Sets the attenuation of the high
frequencies in the delay sound.
When ON, the time value adjusted
by pedal vertical operation will be
synchronized to tempo.
Sets the output level.
#6 Rotary-Z
The rotation speed and width of this rotary speaker simulation can be controlled using
the pedal.
Knob1 Knob2 Knob3
Page01
Speed 0–100
P Width 0–100 P Bal 0–100
Sets the rotation speed.
Sets the width of the high
frequencies.
Sets the balance between the horn
(high frequencies) and drum (low
frequencies).
Page02
Level 0–150 Drive 0–100
Sets the output level.
Sets the amount of amplification of
the preamp.
Z-Pedal Effect Types and Parameters