Specifications

5. To save the new scale to memory, press the STORE key.
Delay Time Calculator Utility
The display will return to the MIDI Harmonized Pitch
Pressing the UTILITY key from Page 2 calls up the
Shift pages. To abandon the new settings, press the
Delay Time Calculator utility.
The calculated value can
CANCEL key.
be used as the delay time for the Hold Delay effect. (See
To use your new User Scale, simply select it with either
page
16 for more information.)
Data
Enby control 2 or 3 from Page 2 of this effect.
Hold Delay
This is a mono hold delay effect with a maximum delay
time of two seconds. The delay time can
be set manually
or tapped in via the
CONTROL IN jack or MIDI.
[ Hold DelayiPage 2 ]
a sec (Delay time coarse): ---, 0.1 - 2.0 seconds
Determines the delay time in units of 100 ms. Turning
Data Entry control
1 all the way counterclockwise selects
the
"no time" setting (---), which automatically sets the
Delay Time Fine parameter below to "Tap".
The Tap setting allows you to set the delay time by
"feel", tapping a signal twice (once for the start
of the
delay, the other for the end). The TRIGGER key, a
switch connected to the
CONTROL IN jack, or a MIDI
control change message can be used for the
tap signal.
(Select the desired
tap source from the Control Source
parameter in Page
3 below.)
a ms (Delay time fine): 0 - 99 ms
Determines the delay time in single millisecond (ms)
units. When the Delay Time Coarse parameter above is
set
to "---", this parameter is automatically set to "Tap",
allowing you to tap in the delay time.
[ Hold DelayIPage 3 ]
a CTL (Control source):
Int.
Trig: TRIGGER key or CONTROL IN on the
front panel
MIDI Trig: MIDI control change message
Determines the tap signal source for setting the delay
time.
22
Section III : Effects and and Their Parameters