Specifications

8
(3) EDIT/CANCEL key
This key allows you to put the 9000 in the Edit mode. Pressing this key allows you also
to cancel the store and some other operations.
(4) AMP/LINE (PARAMETER) key
· In the play mode, this key allows you to select the tone of the 9000 in accordance
with the playback equipment used.
· In the Edit mode, this key allows you to call up the parameter to be edited.
(5) BANK DOWN/UP key
This key allows you to select the desired Bank from Banks 0 to 4. The desired Patch can
be selected by using this key and the PATCH key
(6) PATCH 1 to 4 key
This key allows you to select the desired Patch from within the Bank you selected.
(7) BYPASS/TUNER key
This key allows you to turn off (or bypass) the effect temporarily. The tuning function is
then active while the 9000 is in the bypass mode.
(8) VALUE - / + key
· In the Play mode, normally, this key allows you to control the master volume. In a
Bypass status, this key is used for adjusting the calibration signal to be used as the
reference pitch of the tuner.
· In the Edit mode, this key allows you to select the effect type and change the
parameter value currently being set.
(9) POWER LED
This indicator shows the power-on or power-off status.
Note:
The flashing POWER LED indicates that the batteries are about to run down. When the
POWER LED flashes, replace the batteries. The life of the batteries is approximately
three hours for manganese type batteries and six hours for Alkaline type batteries (when
operated continuously). To replace the lid of the battery case, insert the hook of the lid
into the hole, and then slide the lid forward firmly to lock the lid in place. When the
hook breaks off, start using some good tape to hold it together.