Specifications

27
n FLANGE (Flanger)
This Effect Type adds an effect sound which is delayed by some 10 ms to the direct
sound, and changes the delay time periodically. This effect obtains an intense sound.
When combined with distortion, a swirling flanger sound called “jet sound” is obtained.
[Parameter]
(1) DEPT (Depth): 0 to 10
This parameter determines the depth of the flanger effect.
(2) RATE (Rate): 0 to 50
This parameter determines the speed of the modulation to the flanger
effect.
(3) PEAK (Peak): 0 to 10
This parameter determines the amount of feedback from the effect
output to the input. Increasing this value pronounces the modulation
effect more and gives more intense effect to the sound.
n CHORS1 (Chorus 1)
This Effect Type adds the effect sound whose pitch is modulated periodically, to the
direct sound. This gives a mono chorus effect which has a spatially wide feeling, to the
sound. The principle of this effect is similar to the flanger. However, this effect does not
have the parameters for feedback.
[Parameter]
(1) DEPT (Depth): 0 to 10
This parameter determines the depth of the tone change.
(2) RATE (Rate): 0 to 50
This parameter determines the speed of the tone change.
(3) MIX (Direct/Effect Mix): 0 to 10
This parameter determines the amount of the effect sound with the
direct sound. Setting to 0 outputs only the direct sound, while setting to
10 outputs a maximum of the effect sound.
Helpful hint:
To obtain a comfortable vibration, adjust the depth according to the change of the rate.
n CHORS2 (Chorus 2)
This Effect Type gives a stereo chorus effect to the sound. The stereo effect is only
obtained when played back through stereo headphones or a stereo playback system, as a
single plug connection from the left channel output combines the left and right channels,
reverting the sound back to monaural sound.
[Parameter]
(1) DEPT (Depth): 0 to 10
This parameter determines the depth of the tone change.
(2) RATE (Rate): 0 to 50
This parameter determines the speed of the tone change.
(3) MIX (Direct/Effect Mix): 0 to 10
This parameter determines the amount of the effect sound with the
direct sound. Setting to 0 outputs only the direct sound, while setting to
10 outputs a maximum of the effect sound.