Specifications

g Effect Module 3: Modulation (MOD)

This Effect Module has 11 Effect Types which change tone in time.

n PITCH (Pitch)

This effect Type adds the effect sound with shifted pitch within a range of on octave

above, and/or one octave lower from the original sound, to the direct sound.

[Parameter]

(1) PIT (Pitch): -12 to +12

This parameter determines the difference of pitch at a chromatic

interval. The range which is settable is up and down to one octave.

(2) FIN (Fine): -10 to +10

This parameter adjusts finely the change of pitch.

(3) BAL (Balance): 0 to 10

This parameter determines the volume balance between the effect sound

and the direct sound. Setting to 0 outputs only the direct sound, while

setting to 10 outputs only the effect sound.

Helpful hint:

Setting the (PIT) to 0 and increasing slightly the fine (FIN) gives the chorus effect with

less modulation, to the sound.

n PHASE

This Effect Type adds the effect sound of different phases to the direct sound, and

changes that phase difference in time. A warm, straight tone which is different from

flanger or chorus can be obtained.

[Parameter]

(1) DEPT (Depth): 0 to 10

This parameter determines the depth of the phasing effect .

(2) RATE (Rate): 0 to 50

This parameter determines the waving speed of the phase.

n MID_EQ (Mid-range equalizer)

This Effect Type is a unique effect which uses a phasing effect as an equalizer. This

adds the effect sound of a different phase to the direct sound, and creates peaks and dips

in the frequency response. As a result, the sound in particular ranges is pronounced.

[Parameter]

(1) DEPT (Depth): 0 to 10

This parameter determines the amount of boost for the frequency to be

set with the following FREQ parameter.

(2) FREQ (Frequency): 0 to 50

This parameter determines the center frequency to be boosted.

(3) PEAK (Peak): 0 to 10

This parameter determines the range of the sound to be boosted. The

higher the value is, the narrower the range is set.