Specifications

25
g Effects Module 2: Equalizer (EQ)
This Effect Module includes two Effect Types to control the tone of sounds.
n EQ (Equalizer)
This Effect Type is a tone-control-type equalizer which boosts or cuts high frequencies
and low frequencies independently.
[Parameter]
(1) LO (Low): -7 to +7
This parameter adjusts the sound of the low frequencies.
(2) HI (High): -7 to +7
This parameter adjusts the sound of the high frequencies.
Helpful hint:
It should be noted that equalizers make bad amplifiers. It is better to cut out the stronger
tones, than to push the weaker ones. If you wind up pushing all of the settings here up to
get more volume, you should consider lowering all of them proportionately, and then
raise the Patch volume setting, the Master volume setting, and/or your amplifier volume
instead. You will get better sound that way (with any equalizer).
n ENHANC (Enhancer)
This Effect Type boosts high frequencies to make the sound clear.
[Parameter]
(1) DEPT (Depth): 0 to 10
This parameter determines the amount of sound to be pronounced. The
higher the value is, the deeper the effect is obtained.
(2) FREQ (Frequency): 0 to 10
This parameter determines the frequency to be boosted. The higher the
value is, the more emphasis on the high frequencies is obtained.
Helpful hint:
Giving too much distortion increases the frequency components in the mid-range, and
this may loose clearness of the sound. In this case, use the enhancer to obtain a clear
distortion sound.