Specifications

Restoring Patch settings to the factory-set status (Re-Initialize)

Initialize is a special function which sets all the Patches and other settings of the 9000

back to the factory-set status. Note that when you carry out the initializing function, all

the Patches stored in memory will be deleted, and replaced back to the original factory

settings.

· In the Play mode, hold down the STORE key for ONE SECOND or more,

while holding down the EDIT/CANCEL key.

The contents of the display changes as shown in the following figure.

Displayed Items in the Initializing Standby Status

n To initialize all the Patches, - press the STORE key. “AL” on the display starts

flashing. Then press the STORE key again. (This operation can be canceled by

pressing the EDIT/CANCEL key).

n To stop the initializing operation at half way, - press the EDIT/CANCEL key.

This operation puts the 9000 back into the Play mode.

Helpful hint:

When the initializing function is carried out, calibration settings of the master volume

and the automatic tuning function reference pitch will also be set back to the factory-set

status.