Specifications

BATS AND PORTABLE BATS OPERATION
3-1
3. OPERATION
Once Trackman software is installed (if PC not supplied) and all cables are connected as per section
2;
Open up display panel and keyboard. Turn on Display/Keyboard from rear of unit.
Turn on Transceiver from front of unit.
Turn on Processor from rear of unit and then open up front panel access with key. Press momen-
tary switch at left. See Figure 3-1.
MODEL 4451A “ON” SWITCH
FIGURE 3-1
The Windows® operating system boots-up and starts the EdgeTech BATS Interface (TRACKMAN)
program. The Trackman program automatically sends the previously setup system and target pa-
rameters to the Transceiver upon start-up
4
. The Transceiver returns the status of the system and it
is displayed on the screen. (Also, see “Get BATS Config” under SETUP menu). In a rack mount con-
figuration supplied by EdgeTech, if the power is removed from the unit, the PC automatically starts
and boots into the TRACKMAN program without operator intervention upon return of power.
4
It takes approximately 35 seconds for the Transceiver to boot-up. Wait at least 30 seconds after
booting the PC before setting parameters within TRACKMAN.