Specifications

BATS GENERAL INFORMATION
1-19
1-PPS INPUT
Via rear panel BNC
Accepts a 1-PPS trigger from GPS; Opto-coupler input. Re-
quires ZDA and GGA input also.
ETHERNET
Via Side Panel Connector
Provides communications with PC (Data & Commands)
TRANSMITTER SPECS
Frequency
MF: 15-23kHz, LF: 13-17kHz
Pulse Width
1-15ms in 0.1 ms increments
Repetition Rate
0.5 to 20 seconds
Signal Coding Structure
Various – CW, Chirp (linear), PSK, FSK, REMUS (codes 1-4)
Output Power
100 or 400 Watts into 300 Load
Sound Pressure Level
(Hydrophone Interrogator)
MF: 17-20kHz, @ 400W - Nominal 192dB re 1Pa @ 1m
LF: 13-17kHz, @ 400W - Nominal 192dB re 1Pa @ 1m
HYDROPHONE/INTERROGATOR
MODEL 4213C-B
Diameter
2.9 inches (7.4 cm)
Height
19.4 inches (49.3 cm)
Weight
10 lbs (4.5kg)
Temperature Rating
Operating: -4° to 40° C Storage: -40° to 70° C
Frequency
MF: 17-30kHz or LF: 8-16kHz
DECK CABLE
MODEL 4113C
Length
50ft (15m) or 100ft (30m)
Diameter
1.38 in (3.5cm)
Weight
50ft- 7 lbs (3.2kg) or 100ft - 14 lbs (6.4kg)
Transceiver to PC S/W Requirement Spec
Set up of parameters for the BATS is via Windows based software (Trackman). Command and con-
figuration via a menu driven parameter listing. This Windows based software performs the following
functions, data display, multiple target plotting, command and configuration setup, and beacon po-
sition output to a Navigation Processor. The software receives the raw phase / timing data from the
USBL Processor Module and uses it to calculate the final X, Y & Z position of each target. This