Specifications

BATS AND PORTABLE BATS OPERATION
3-36
The setup parameters for the TrackPoint BATS Device are…
 Connection Type IP (net)
 IP Network Settings TCP
 IP Address 192.168.3.X (X usually = 9 but check on top
cover of the BATS Transceiver for IP address.)
 Port Number 50001
 Sentence Input to Trackman TP_SPC (TrackPoint Signal Processor Commands)
 Use Checksum Yes
 Sentence Output from Trackman TP_SPC (TrackPoint Signal Processor Commands)
Once this connection protocol has been setup perform a “Find BATS” command under the setup
main menu. Trackman will then find any BATS on the network connection. Click on “connect to” to
make connection to the BATS. Under the USBL main menu click on “get Status”. If communications
have been established the “Get Status” box will be shown
Remote Interface:
Not common. The Remote Interface port is typically for an output to a navigation system that also
communicates with Trackman. Setup the Remote Interface device to output the format that is
compatible with the navigation software. The Connection Type can be either “COM Port” or “IP
(net)”.
The Sentence Input to Trackman can either be “NCSS” or SPC. This is the data format that is
coming from the Remote Control Module (another PC) to this PC or laptop. These are not typical
and are only used for special applications. Leave as “----“. For data output only see Data Output
below. The Sentence Output from Trackman is the data format sent from the PC to the Naviga-
tion System. The list of formats available are; PORE, POREB, POREG, SNTTM, STANDARD, STAND-
ARD-EC, STD W/PR, STD-EC W/PR, NCSS, NCSS-EC, NUWC, NUWC-EC, REV 4 & REV 4-EC.