Specifications

BATS AND PORTABLE BATS OPERATION
3-26
PEIV1 - Depth of Target (EIVA Navipak)
1 2 3
| | |
$PEIV1,x.x,yy*hh<CR><LF>
1) Depth, meters (Referenced to Water surface)
2) Target Number 01-99
3) Checksum
DPT - Depth - Deviation & Variation
1 3 4
| | |
$--DPT,x.x,x.x*hh<CR><LF>
Field Number:
1) Depth, meters (Water depth below TP3 Hydrophone)
2) Offset from transducer, Positive means distance from transducer to water line nega-
tive means distance from transducer to keel
3) Checksum
NOTE: Offsets are not used. The BATS uses Depth to the transducer in its calculations.
 Filtering Tab
The “Filtering Tab” allows each
beacon to have individual fil-
tering parameters, configuring
each beacon for its own track-
ing scenario. Select Filter Level
for the beacon in use. In the
case of a fast moving target
set the level between 1 and 5
with 1 being for minimal filter-
ing and 5 being for moderate
filtering. For slower moving
targets set level between 6
and 10 with the filtering pa-
rameters increasing to maxi-
mum at 10. To set limits on
known target locations modify
the Slant Range and Bearing
parameters.
When  OK is selected the Trackman program sends the parameters to the Transceiver. This delay
causes the dialog box to remain on screen for a few seconds following the command.