User manual

1 In the Authentication drop down bar select WPA – PSK/WPA2 – PSK. If you
know all your devices support WPA2-PSK you can select it instead. This is
the default setting.
2 In the Security Key field enter a value for the key. The maximum value is 42
characters. The minimum value is 8 characters. By default a Security Key is
programmed into your unit at the factory. This Security Key is found on the
bottom label of your unit. Most users should use this key.
3 If you change the Security Key write it down and put it where you can find it –
on the bottom of the case, for instance.
4 Click Save. If you are connected wirelessly to the Modem/Router you will lose
the connection as soon as you click Save. When you re-establish your
wireless connection you will be prompted for the security key that you just
entered. You must enter this key to be able to connect to the Modem/Router.
5 Now you need to set up each of your wireless devices with the Security Key
that you entered. See
Establishing your Wireless Network on page 28 for
instructions on connecting devices to the Modem/Router.
62 3G+ Modem/Router with Wireless-N and Phone Port User Manual